Xiaomi Redmi Note 8 Pro IMEI Repair (Special Lecture)
To perform these operations.
Your hand is; Maui META ver 10.1816.0.01
MiFlashPro
Minimal ADB and Fastboot
It should be, and I will share it below.
Turn on USB Debugging the device clearly. and give adb permission.
We call it "adb reboot bootloader" later, the device will be taken in fastboot mode.
After getting fastboot mode of your device, we open "MiFlashPro".
Open "Mi Flash" on the screen that comes up, we select our ENG firmware file.
Important notice: No matter how much you do on your flash or flash, select "clean all" under the flash tool on the right,
otherwise the bootloader lock will be closed and you cannot do anything.
When your device is in fastboot mode, we say "refresh", after seeing com of your device, we say "flash".
After installing ENG Firmware, we explicitly call it "adb reboot bootloader". and write the following commands.
1) fastboot erase nvram
2) fastboot erase nvdata
3) fastboot reboot When
your device turns on, the image will be reset later .
Now turn off your device and open this version of "Maui META ver 10.1816.0.01".
When the device is off, we say "Connect" below on the right and connect the device.
The process after reading your device IMEI Repair,
The original software of the device is Global software. Information: begonia, Stable, Recovery, Global, 9.0.
ENG Firmware.
To perform these operations.
Your hand is; Maui META ver 10.1816.0.01
MiFlashPro
Minimal ADB and Fastboot
It should be, and I will share it below.
Turn on USB Debugging the device clearly. and give adb permission.
We call it "adb reboot bootloader" later, the device will be taken in fastboot mode.
After getting fastboot mode of your device, we open "MiFlashPro".
Open "Mi Flash" on the screen that comes up, we select our ENG firmware file.
Important notice: No matter how much you do on your flash or flash, select "clean all" under the flash tool on the right,
otherwise the bootloader lock will be closed and you cannot do anything.
When your device is in fastboot mode, we say "refresh", after seeing com of your device, we say "flash".
After installing ENG Firmware, we explicitly call it "adb reboot bootloader". and write the following commands.
1) fastboot erase nvram
2) fastboot erase nvdata
3) fastboot reboot When
your device turns on, the image will be reset later .
Now turn off your device and open this version of "Maui META ver 10.1816.0.01".
When the device is off, we say "Connect" below on the right and connect the device.
The process after reading your device IMEI Repair,
The original software of the device is Global software. Information: begonia, Stable, Recovery, Global, 9.0.
ENG Firmware.
