FRP Bypass Tool Sam Android 16 2025 Edition

GsmSanjoy · Tuesday at 3:34 AM

Samsung Android 16 FRP Tool – Full Guide & Free Download

This guide explains how the tool works, what you need, and how to use it safely on supported Samsung devices.

Important Note (Please Read)

This tool is not tested on all Samsung models. It was tested on only one device, and the method worked on that particular unit.
Since this is a test version, results may vary depending on your device model or firmware. If anything fails or an error appears, please do not blame the developer.
Use this tool at your own risk. It is released for testing and may behave differently on different versions.

Key Features of This FRP Tool

1. Auto Modem Detection

No need to manually find COM ports.
The tool automatically detects the Samsung Mobile USB Modem as soon as your device is connected.

2. Advanced Info Reading

The tool uses:

AT+DEVCONINFO
Standard AT Commands

It accurately reads Model, IMEI, and Software Version—even on higher Android security patches.

3. Android 16 Support

The exploit is updated for 2025 security patches and can successfully trigger the USB Debugging popup on Android 16.

4. One-Click FRP Remove

Once ADB is enabled, just hit the remove button and the tool will:

Bypass FRP
Skip Setup Wizard
Reboot the device (if required)

5. Clean Log System

Green = Success messages
Red = Errors
Clear button layout for better workflow

What You Need Before Starting

Samsung USB Drivers installed
A stable USB cable
Wi-Fi enabled on the locked phone
ADB files (adb.exe + required DLLs) in the same folder as the tool

How to Use the Tool (Step-by-Step)

Step 1: Connect Your Phone & Read Info

Run SamsungFRP_GSMYOGESH.exe as Administrator.
Connect your Samsung device.
Click Refresh → The modem port should be detected automatically.
Click READ INFO.

If Model + IMEI appear correctly → You’re ready.
If "Unknown" appears → Reconnect the cable and try again.

Step 2: Enable ADB (Exploit Mode)

Click STEP 1: ENABLE ADB (2025).
The tool sends the payload.
Check your phone screen.
A popup will appear: Allow USB Debugging?

Tick Always allow from this computer → Tap Allow.

Step 3: Remove FRP Permanently

Go back to the tool.
Click STEP 2: REMOVE FRP (ADB).

Your phone will reboot or directly reach the home screen. FRP successfully removed.

Troubleshooting Tips

1. “Ver: Empty” or “Unknown”

Use a better USB cable
Close Odin/Kies or any Samsung app
Try Read Info again

2. USB Debugging Popup Didn’t Appear

Reconnect cable
Restart phone
Try again from Step 1
#0# test mode may also help

3. “ADB Device Not Found”

You didn’t press Allow fast enough
Reconnect and repeat Step 2

Download Links

FRP Bypass Tool Sam Android 16 2025 Edition